Graphtec Ce2000 60 Software Cutting Master

It is recommended using plug-in software Cutting Master 4 corresponded to new OS or application software if possible.

Graphtec Ce2000 60 Free From Profanity

In addition, no claim is made that posts made here will be free from profanity, obscenity, rude, hurtful, libelous or insulting opinions of the poster.

By continuing to use this site, you are agreeing to our use of cookies.

Learn More.

I went to cut some paint mask on my Graphtec today and had this happen.

You can see the variation in the line weight on my border, and also the point at the bottom of the curve where the cut didnt meet up correctly.

I thought at first maybe it was dirty pinch rollers, so I cleaned them well with alcohol.

I also fed the vinyl off the roll to make sure it feed smoothly, but the same thing happened with the second attempt.

What do the grit rollers tension levers on the back look like.

Slow it down. The knife might not be able to get through that paint mask fast enough so as it rolls its pulling or pushing and moving the mask around a little.

Have you changed your cutting strip Have you changed your blade Is the carriage solid on the rail or can you wiggle it forwards and backwards.

I dont cut much at all, (a couple times a month) so Im pretty certain the blade is good.

Hey Phillip, does that plotter have an adjustment for the pinchroll pressure It almost looks like the vinyl is slipping when its going back and fourth in the cutter.

Does it do it on regular vinyl or just the paintmask Do you have a pen attachment on your plotter you can use on some paper to see if you get the same results (That would rule out the knife and cutting strip) Last test would be to try a different file, sometimes files just get sent over funny.

I havent had this issue before, this is the first time trying the paint mask.

I noticed that at the end of the cut, the vinyl seems to be lifting, or bunching a bit by the right pinch roller, like the pinch rollers arent tight enough to keep it taught.

There isnt a pressure adjustment on the rollers that I can see.

I went ahead and ordered the pinch rollers and cutting strip this afternoon from Wensco since Ive never replaced them and who knows the last time it was done.

According to the manual you might want to check the step size and make sure they are set to the same value on the cutter and in the software.

Congrats on keeping that old thing up and running for so long.

Graphtec should send you a T-shirt like they used to do with the Ford Bronco if you maintained it past 300,000 miles.

As such, each reader should not rely on any information available here as accurate and should independently verify such accuracy.

Graphtec Ce2000 60 Driver For Mac